Welcome to the Alteryx Knowledge Base

Designer Cloud workflow fails with the error - No fields have been selected for output
user

Created/Edited - 3/5/2026 by Marni Monika | Alteryx

Description

A Designer Cloud job fails repeatedly with an engine error, even though no visible configuration errors appear in the workflow.

The failure occurs when the workflow output is configured to overwrite an existing file, but the file does not exist in the published location.

Issue

The workflow fails with the following error messages:

Error ToolId: No fields have been selected for output. The Engine encountered a problem, and a report was sent to Al.

The workflow shows no errors during design time, but the job fails during execution.

Environment

Designer Cloud

Cause

The workflow output was configured to overwrite an existing file

However, the file did not exist in the user’s published location. When the job attempted to overwrite a non-existent file, execution failed and triggered the error.

Resolution
  1. Edit the workflow and locate the output configuration.
  2. Change the output to use a new table or file name.
  3. Enable the Overwrite option.
  4. Re-run the job.

After updating the output configuration to create a new table/file and then applying the Overwrite option, the job should run successfully.

Was this article helpful?